It will then be ready to program.
How to program your garage door remote control.
Simply click on your garage door opener model to access the appropriate owner s manual that includes the programming instructions for your garage door remote control.
Test the new garage door remote by pressing once to see if the door moves.
Press and immediately release the learn button.
Program using your garage door opener learn button.
Locate the learn button on the garage door opener.
While the indicator light is blinking press the button on your remote.
Hold the button down until the activator light on the garage door opener starts flashing then release the button.
If there is a window you can climb through another small door to the garage or some way of getting inside the garage other than the car entrance you can get a new remote programmed.
The garage door opener lights will flash or two clicks will be heard.
Here are the basic steps for programming a remote control to a garage door opener.
Within 30 seconds press the button on the remote control that you wish to operate your garage door.
Locate the learn button on the door control.
The led will blink.
Press the learn button twice.
The learn led will glow steadily.
Garage door openers have a manual button that will allow you to operate the garage door without the remote control.
Programming an overhead door remote control depends on the model garage door opener you have installed in your garage.
Listed below are some of the most common overhead door garage door openers.
The garage door opener lights will flash or two clicks will be heard.
The remote control is programmed.
Step 4 replace the opener s plastic light cover if applicable and test the remote control for proper activation of the garage door opener.
Locate the program button on your garage door opener or keypad.
Depress and hold the button labelled l learn or set on the new remote control unit.
Press and release the button on the remote control that you wish to operate your garage door.