How To Repair Pocket Door Rollers

However if one side of the wall is wallpapered cut through the other side of the wall to save the paper.

How to repair pocket door rollers.

Since there are different hardware styles for the rollers on pocket doors it is hard to say how you would repair it. I tried but i can t reach it because the opening is too small for my fingers. Unscrew the frame which keeps the roller in place and then remove these metal brackets. You can remove the old door by tilting it down and taking it out from the rollers.

Use a flashlight so that you can see what you are doing. Remove a door from a j track by following the instructions in photo 5 but instead of pulling the top toward you push away to pop the rollers out of the track. Pocket door rollers standards. You will now have complete access to the roller and track.

1 use a utility knife to break the paint seal along the stop moldings on each door jamb and then carefully pry off the moldings with a chisel or a 5 in 1 tool and flat bar. With the broom handle slide the roller carriage out into the door opening. One of the rollers seems to be disconnected and possibly off the track. Pull out a door that s stuck in the pocket by alternately pulling the top and bottom edges.

New track and pocket door rollers. A broom handle works well for coaxing the hanger out of the pocket. You might think that something as common as pocket doors that there would be some standards. Unfortunately there are not.

After the door is taken out and leaned against the wall you will have to locate the pocket door hanger. 2 position the door so that it s centered in the doorway tilt it toward the room and lift the rollers out of the overhead track. Putting the pocket door back on the track. If and only if you are confident the repair can be done that way.

Replacing pocket door rollers is not too hard if you have the right ones to replace them with. As the first step of pocket door replacement you will need to cut a hole in the wall for access to the rollers and the track system in addition to removing the frame of the door. You will need these and the screws they came with when you are fitting the new roller. A step by step guide on how i repaired this pocket door that had come off one of its rollers.

There are some concerns with attempting to replace the rollers. Remove a door with roller skate type rollers by prying the door up and tapping on the rollers to release them. Drill or cut a 3 to 4 diameter hole at the proper height on the side of the door that allows the best view of the track and hardware. You will need to open the door as wide as possible and find the base where the roller is.